{"draft":"draft-ietf-roll-mpl-parameter-configuration-08","doc_id":"RFC7774","title":"Multicast Protocol for Low-Power and Lossy Networks (MPL) Parameter Configuration Option for DHCPv6","authors":["Y. Doi","M. Gillmore"],"format":["ASCII","HTML"],"page_count":"10","pub_status":"PROPOSED STANDARD","status":"PROPOSED STANDARD","source":"Routing Over Low power and Lossy networks","abstract":"This document defines a way to configure a parameter set for MPL\r\n(Multicast Protocol for Low-Power and Lossy Networks) via a DHCPv6\r\noption.  MPL has a set of parameters to control its behavior, and the\r\nparameter set is often configured as a network-wide parameter because\r\nthe parameter set should be identical for each MPL Forwarder in an\r\nMPL Domain.  Using the MPL Parameter Configuration Option defined in\r\nthis document, a network can easily be configured with a single set\r\nof MPL parameters.","pub_date":"March 2016","keywords":["MPL","DHCPv6"],"obsoletes":[],"obsoleted_by":[],"updates":[],"updated_by":[],"see_also":[],"doi":"10.17487\/RFC7774","errata_url":"https:\/\/www.rfc-editor.org\/errata\/rfc7774"}